Onboard Fdc Controller; Onboard Serial Port; Uart Mode Select; Ir Transmission Delay - Albatron PX925XE Series User Manual

PX925X/PX925XE Series

Onboard FDC Controller

Select "Enabled" if your system has a floppy disk controller (FDC) installed on the system
board and you wish to use it. If you install an add-in FDC or the system has no floppy drive,
select "Disabled". Options: Enabled (default)、Disabled

Onboard Serial Port 1-2

Select an address and corresponding interrupt for the first/ second serial port.
Options: Disabled、3F8/IRQ4 (default for port1)、2F8/IRQ3 (default for port2)、3E8/IRQ4、
2E8/IRQ3、Auto

UART Mode Select

This item allows you to select the Infra Red (IR) standard to be used.
Options: Normal (default)、IrDA
RxD, TxD Active
This item determines the RxD and TxD frequencies. This field only configurable if "UART
Mode Select" is set to "ASKIR" or "IrDA". Options: Hi / Lo (default)、Hi / Hi、Lo / Hi、Lo / Lo

IR Transmission Delay

This item allows you to enable/disable IR transmission delay. This field only configurable if
"UART Mode Select" is set to "ASKIR" or "IrDA". Options: Enabled (default)、Disabled

UR2 Duplex Mode

Select the transmission mode used by the IR interface. Full-duplex mode permits
simultaneous bi-directional transmission. Half-duplex mode permits transmission in only
one direction at a time. This field only configurable if "UART Mode Select" is set to "ASKIR"
or "IrDA". Options: Half (default)、Full
Use IR Pins
Consult your IR peripheral documentation to select the correct setting of the TxD and
RxD signals. This field is only configurable if "UART Mode Select" is set to "ASKIR" or "IrDA".
Options: RxD2、DxD2 (default)

Onboard Parallel Port

Select an address and corresponding interrupt for the onboard parallel port.
Options: 378/IRQ7 (default)、278/IRQ5、3BC/IRQ7、Disabled

Parallel Port Mode

This option allows you to select a parallel port mode for the onboard parallel port.
Options:
ECP (default) Extended Capabilities Port.
EPP Enhanced Parallel Port.
SPP Standard Printer Port.
ECP+EPP ECP & EPP mode.
Normal
36