Hdd Power Down; Suspend Mode; Video Off Method; Modem Use Irq - Albatron PM800 Series User Manual

3. User Defined (default)
Allows you to set each mode individually.
When this option is enabled, the "suspend mode" time is configurable from 1 minute to 1 hour. The
HDD Power Down, which ranges from 1 min. to 15 min. and includes a "disable" option.
Note: If you select Min. or Max. Power Saving modes, the "HDD Power Down" value and the "Suspend
Mode" value are both fixed.

HDD Power Down

When enabled, the hard disk drive will power down after a certain configurable period of system
inactivity. All other devices remain active.
Options: Disabled (default)、1 Min、2 Min、3 Min、4 Min、5 Min、6 Min、7 Min、8 Min、9 Min、10 Min、
11 Min、12 Min、13 Min、14 Min、15Min

Suspend Mode

This item allows you to select the period of inactivity before the system is suspended or put into
suspend mode. Options: Disabled(default)、1Min、2Min、4Min、6Min、8Min、10Min、20Min、30Min、
40Min、1Hour
Video Off Option
This field determines when to activate the video off feature for monitor power management. Options:
Suspend→Off (default), Always On.

Video Off Method

This option determines the manner in which the monitor goes blank.
Options:
V/H SYNC+Blank
Blank Screen (default)
DPMS Support

Modem Use IRQ

This determines the modem's IRQ. Options: 3 (default)、4、5、7、9、10、11、NA.
Soft-Off by PWRBTN
Pressing the power button for more than 4 seconds forces the system to enter the
Soft-Off state when the system has "hung." Options: Delay 4 Sec, Instant-Off (default).
Run VGABIOS if S3 Resume
Select whether you want to run VGABIOS when the system wakes up from the S3 resume function.
Options: Auto (default)、Yes、No
This selection will cause the system to turn off the vertical and
horizontal synchronization ports and write blanks to the video buffer.
This option only writes blanks to the video buffer.
Initial display power management signaling.
38
PM800 Series