Power On Function; Onboard Fdc Controller; Uart Mode Select; Ir Transmission Delay - Albatron PX845PE Series User Manual

Onboard I/O Chip Setup
If you highlight the "Onboard I/O Chip Setup" label and then press the enter key, it will take
you to a submenu with the following options:
PWRON After PWR-Fail
This field will determine whether your system will boot after restoring power after a power
failure. If you select "On", the system will boot whether or not the system was on before
power failure. If you select "Former-Sts", the system will be restored to the status before the
power failure. Options: Off (default)、On、Former-Sts

Power On Function

This option allows you to select a way to power on your computer. Options: Password、Hot
KEY、Mouse Left、Mouse Right、Any KEY、BUTTON ONLY (default), and Keyboard 98
KB Power On Password
Supply a password that your system will use as part of the power-on sequence.
Hot Key Power ON
This option allows you to use the Ctrl key along with a hot key (function key) to power on
your system. Options: Ctrl-F1、Ctrl-F2...... Ctrl-F12

Onboard FDC Controller

Select "Enabled" if your system has a floppy disk controller (FDC) installed on the system
board and you wish to use it. If you install an add-in FDC or the system has no floppy drive,
select "Disabled". Options: Enabled (default)、Disabled
Onboard Serial Port 1/ Port 2
Select an address and corresponding interrupt for the first/ second serial port.
Options: Disabled、3F8/IRQ4 (default for port1)、2F8/IRQ3(default for port2)、3E8/IRQ4、
2E8/IRQ3、Auto

UART Mode Select

This item allows you to select the Infra Red (IR) standard to be used.
Options: Normal (default)、AS KIR、IrDA
RxD, TxD Active
This item determines the RxD and TxD frequencies.
Options: Hi / Lo (default)、Hi / Hi、Lo / Hi、Lo / Lo

IR Transmission Delay

This item allows you to enable/disable IR transmission delay.
Options: Enabled (default)、Disabled
44
PX845PE/GE Series