Onboard Fdc Controller; Uart Mode Select; Ir Transmission Delay; Ur2 Duplex Mode - Albatron PX865PE PRO II User Manual

PX865PE PRO II

Onboard FDC Controller

Select "Enabled" if your system has a floppy disk controller (FDC) installed on the system board and
you wish to use it. If you install an add-in FDC or the system has no floppy drive, select "Disabled".
Options: Enabled (default)、Disabled
Onboard Serial Port 1/ Port 2
Select an address and corresponding interrupt for the first/ second serial port.
Options: Disabled、3F8/IRQ4 (default for port1)、2F8/IRQ3(default for port2)、3E8/IRQ4、
2E8/IRQ3、Auto

UART Mode Select

This item allows you to select the Infra Red (IR) standard to be used.
Options: Normal (default)、ASKIR、IrDA
RxD, TxD Active
This item determines the RxD and TxD frequencies. This field is only configurable if "UART Mode
Select" is set to "ASKIR" or "IrDA". Options: Hi / Lo (default)、Hi / Hi、Lo / Hi、Lo / Lo

IR Transmission Delay

This item allows you to enable/disable IR transmission delay. This field is only configurable if
"UART Mode Select" is set to "ASKIR" or "IrDA". Options: Enabled (default)、Disabled

UR2 Duplex Mode

Select the transmission mode used by the IR interface. Full-duplex mode permits simultaneous
bi-directional transmission. Half-duplex mode permits transmission in only one direction at a time.
This field is only configurable if "UART Mode Select" is set to "ASKIR" or "IrDA".
Options: Half (default)、Full

Use IR Pins

Consult your IR peripheral documentation to select the correct setting of the TxD and RxD signals.
This field is only configurable if "UART Mode Select" is set to "ASKIR" or "IrDA".
Options: Full、Half (default)

Onboard Parallel Port

Select an address and corresponding interrupt for the onboard parallel port.
Options: 378/IRQ7 (default)、278/IRQ5、3BC/IRQ7、Disabled
38