Connectors - Albatron PM800 Series User Manual

Connectors

Floppy Disk Connector: FDC
This mainboard provides a standard floppy disk connector (FDC) that supports 360K, 720K, 1.2M, 1.44M
and 2.88M floppy diskettes. This connector supports the floppy drive ribbon cables provided in the
packaging.
Hard Disk Connectors: IDE1-2、SATA1-2
This mainboard has a 32-bit Enhanced PCI IDE Controller that supports PIO Mode 4, DMA mode, Ultra
ATA 66/ 100/ 133. This mainboard provides two IDE connectors, IDE1 (primary) and IDE2 (secondary).
This mainboard also provides two serial ATA connectors.
IDE1 (Primary IDE Connector)
You can connect up to two hard drives to IDE1. If you attach two drives, you must use a ribbon cable
with three connectors. You must also configure one drive as the master and one drive as the slave,
using the jumpers located on each drive.
IDE2 (Secondary IDE Connector)
The IDE2 connector can also support a Master and a Slave drive. The configuration is similar to IDE1.
The second drive on this controller must be set to slave mode.
SATA1/ SATA2
The SATA connectors support transfer rate to 150 MB/s and SATA RAID 0 or 1 mode. The connectors
only can connect one serial ATA hard disk device each.
SATA2
SATA 1
This mainboard supports SATA RAID 0 or 1. See appendix II for more
information.
IDE1
IDE2
DI M M 1
DI M M 2
16
PM800 Series
FDC