Power On Function; Kb Power On Password; Hot Key Power On; Onboard Fdc Controller - Albatron PX915P4 Series User Manual

PX915P4/ PX915G4 Series
IDE RAID Device
This item allows you to enable or disable the IDE RAID Device. Options: Enabled (default)、Disabled
Onboard I/O Chip Setup

Power On Function

This option allows you to select a way to power on your computer. Options: Password、Hot KEY、Mouse
Left、Mouse Right、Any KEY、BUTTON ONLY (default), and Keyboard 98

KB Power On Password

This it the password that your system will use as part of the power-on sequence. This field is only
configurable when "Power On Function" is set to "Password".

Hot Key Power ON

This option allows you to use the Ctrl key along with a hot key (function key) to power on your system.
This field is only configurable when "Power On Function" is set to "Hot Key".
Options: Ctrl-F1、Ctrl-F2...... Ctrl-F12

Onboard FDC Controller

Select "Enabled" if your system has a floppy disk controller (FDC) installed on the system board and you
wish to use it. If you install an add-in FDC or the system has no floppy drive, select "Disabled". Options:
Enabled (default)、Disabled
Onboard Serial Port 1/ 2
Select an address and corresponding interrupt for the first/ second serial port.
Options: Disabled、3F8/IRQ4 (default for port1)、2F8/IRQ3、3E8/IRQ4、2E8/IRQ3、Auto

UART Mode Select

This item allows you to select the Infra Red (IR) standard to be used.
Options: Disabled (default)、ASKIR、IrDA
RxD, TxD Active
This item determines the RxD and TxD frequencies. This field only configurable if "UART Mode Select"
is set to "ASKIR" or "IrDA". Options: Hi / Lo (default)、Hi / Hi、Lo / Hi、Lo / Lo

IR Transmission Delay

This item allows you to enable/disable IR transmission delay. This field only configurable if "UART Mode
Select" is set to "ASKIR" or "IrDA". Options: Enabled (default)、Disabled
35