Onboard Lan Boot Rom; Usb Controller; Usb Keyboard Support; Super Io Device - Albatron PM800 Series User Manual

PM800 Series

Onboard Lan Boot ROM

Decide whether to invoke the boot ROM of the onboard LAN chip.
Options: Enabled、Disabled (default)

USB Controller

This option should be enabled if your system has a USB port installed on the system board. You will
need to disable this feature if you add a higher performance controller.
Options: All Enabled (default)、All Disabled
USB 2.0 Support
This option should be enabled if your system has a USB 2.0 device installed on the system board. You
will need to disable this feature if you install a USB 1.1 device.
Options: Enabled (default)、Disabled

USB Keyboard Support

Enables support for USB attached keyboard. Options: Disabled (default)、Enabled

Super IO Device

If you highlight the literal "Press Enter" next to the "Super IO Device" label and then press the enter
key, it will take you a submenu with the following options:

Onboard FDC Controller

Select Enabled if your system has a floppy disk controller (FDC) installed on the system board and you
wish to use it. If you install an add-in FDC or the system has no floppy drive, select "Disabled" in this
field. Options: Enabled (default)、Disabled

Onboard Serial Port 1

Select an address and corresponding interrupt for the first serial port.
Options: Disabled、 3F8/IRQ4 (default)、 2F8/IRQ3、 3E8/IRQ4、 2E8/IRQ3、 Auto

Onboard Serial Port 2

Select an address and corresponding interrupt for the second serial port.
Options: Disabled、2F8/IRQ3 (default)、3F8/IRQ4、3E8/IRQ4、2E8/IRQ3、Auto.

UART Mode Select

This item allows you to select the Infra Red (IR) standard to be used.
Option: Normal (default)、IrDA、ASKIR。
RxD, TxD Active
This item determines the RxD and TxD frequencies. This field only configurable if "UART Mode Select"
is set to "ASKIR" or "IrDA". Options: Hi/ Lo (default)、Hi/ Hi、Lo/ Hi、Lo/ Lo
35