Hardware Installation; Cpu Processor Installation - Albatron PM800 Series User Manual

Hardware Installation

This section will assist you in quickly installing your system hardware. Wear a wrist ground strap before
handling components. Electrostatic discharge may damage your system components.

CPU Processor Installation

This mainboard supports Intel
we suggest you visit the Intel website
procedures.
CPU Socket 478 Configuration Steps:
1. Locate the CPU socket on your mainboard and nudge the lever away from the socket. Then lift the
lever to a 90-degree angle.
2. On the socket, locate the corner that has the pin-1 receptor. This corner will be near to the end of
the lever. Match the dot on the CPU with the pin-1 receptor on the socket and lower the CPU onto
the socket. The b ottom of the CPU should be flush w
3 . Lower the lever until it snaps back into position. This will lock down the CPU.
4 . Sm ear thermal g rease on top of the CPU. Lower the CPU fan onto the CPU
fan to attach it to the socket. Finally, extend th
CPUFAN adapter .
F
® ®
Pentium 4 processors using a Socket 478. Before building your system,
http://www.intel.com
ith the face of the socket.
Pin1 Receptor
e power cable from the fan and insert it onto the
Attention: Before starting the system
Please recheck the installation procedures completely before
starting the system. Verify that the heatsink is prop
and make sure the CPU fan is working. Overheating can
damage the CPU and other sensitive components.
10
PM800 Series
and review the processor installation
Dot
and use the clasps on the
erly installed