Table of Contents
Advertisement
PM266A PRO/ PM266A
USB 2.0 Support
This option should be enabled if your system has a USB 2.0 device installed on the system board.
You will need to disable this feature if you install a USB 1.1 device.
Options: Enabled (default)、Disabled
USB Keyboard Support
Enables support for USB attached keyboard. Options: Disabled (default)、Enabled
Super IO Device
If you highlight the literal "Press Enter" next to the "
Super IO Device" label and then press the enter
key, it will take you a submenu with
the following options:
Onboard FDC Controll
er
Select Enabled if your system has a floppy disk controller (FDC) installed on the system board and
you wish to use it. If you install an add-in FDC or the system has no floppy drive, select "Disabled"
in this field. Options: Enabled (default)、Disabled
O
nboard Serial Port 1
Select an address and corresponding in
terrupt for the first serial port.
Options: Disabled、 3F8/IRQ4 (default)、 2F8/IRQ3、 3E8/IRQ4、 2E8/IRQ3、 Auto
Onboard Seri
al Port 2
Select an address and corresponding interrupt for the second se
rial port.
Options: Disabled、2F8/IRQ3 (defa
ult)、3F8/IRQ4、3E8/IRQ4、2E8/IRQ3、Auto.
UART Mode Select
This item allows you to select the Infra Red (IR) standard to be
used.
Option: Normal (default)、IrDA、ASK
IR。
RxD, TxD Active
This item determines the RxD and TxD frequencies. This field only configurable if "UART Mode
Select" is set to "ASKIR" or "IrDA". Options: Hi/ Lo (default)、Hi/ Hi、Lo/ Hi、Lo/ Lo
IR
Transmission Delay
This item allows you to enable/ disable IR transmission delay. This field only configurable if "UART
Mode Select" is set to "ASKIR" or "IrDA". Options: Enabled (default)、Disabled
33
Hide quick links:
Advertisement
Table of Contents
