Appendix] Manual Setup; Channel & Trace Setup - Agilent Technologies E5071C Compliance Tests

Agilent MOI for MHL Cables Compliance Tests

6. [Appendix] Manual Setup

The procedures of manual setup for time-domain and frequency-domain measurements are
introduced in the section. All the following parameters are saved in the E5071C's state file,
which is available at:
6.1. Channel & Trace Setup
If TDR setup wizard is shown when launching the TDR software, click
TDR setup wizard main window.
1. Open Setup tab in the TDR software.
2. Click Preset to preset the instrument. Click
3. Set DUT Topology
4. Click Advanced
5. A dialog box appears requesting for confirmation. Then click Yes. (Clear the check box
for "Use Advanced Calibration Methods")
6. Click Stop Single.
7. Open TDR/TDT
8. Click Trace Control
9. Clear Time and
www.agilent.com/find/ena-tdr_mhl-cabcon
to "Single-Ended 4-Port". Click
Mode>>.
tab.
tab.
Marker check box under Coupling.
OK in a dialog box to continue.
OK in a dialog box.
26
Close button in the