Lmc; Lrn; Opc - HP E1340A User Manual

*LMC?

*LMC?
Comments

*LRN?

Note
Comments

*OPC

Comments
192 HP E1340A Command Reference
*LMC? returns a comma-separated list of quoted strings, each containing the
name of a macro. If no macros are defined, a single null string ("") is
returned.
Executable when initiated: Yes
Coupled command: No
Related Commands:
*RST Condition: none
Power-On Condition: no macros are defined
*LRN? returns a sequence of commands that may be resent to the HP
E1340A to return it to its current programming state.
Only those commands that are affected by
sequence. Notable exceptions include the DAC code format (signed vs.
unsigned), the SOURce:LIST1|2
segment sequence, and frequency list definitions, the
commands, and the
CALibration:STATe
*LRN? should be sent singly in a program message, since the number of
commands in the returned sequence is large, and may vary depending on
firmware revision.
Executable when initiated: Yes
Coupled command: No
Related commands:
*RST Condition: none
*OPC causes the E1340A to wait for all pending operations to complete.
The Operation Complete bit (bit 0) in the Standard Event Status Register is
then set.
If
STATus:OPC:INITiate OFF
when all commands received prior to the
is set, *OPC waits for waveform generation to complete before setting the
Operation Complete bit. No other commands will be executed until the
Operation Complete bit is set.
Executable when initiated: Yes
Coupled command: No
Related commands:
*RST Condition: none
*DMC
are included in the
*RST
commands, including waveform segment,
and
SECurity
*RCL , *RST , *SAV
is set, the Operation Complete bit will be set
*OPC have been executed. If
*OPC? , *WAI
subsystem
STATus
command states.
ON
Chapter 7