Cls; Dmc - HP E1340A User Manual

c
Comments

*DMC

Parameters
Comments
Example
Chapter 7

*CLS

*CLS clears the Standard Event Status Register, the Operation Status
Register, the Questionable Signal Register, and the error queue. This clears
the corresponding summary bits (3, 5, and 7) in the Status Byte Register.
*CLS does not affe
Executable when initiated: Yes
Coupled command: No
Related Commands:
*RST Condition: none
*DMC < name
zero, one, or a sequence of commands to the name. The sequence may be
composed of SCPI and/or Common Commands. The sequence may be sent
in IEEE-488.2 definite or indefinite block format or as a quoted string.
Parameter
Name
name character data
data
Legal macro names must start with an alphabetic character and
contain only alphabetic, numeric, and underscore ("_") characters.
Alphabetic character case (upper vs. lower) is ignored.
The name is allowed to be the same as a SCPI command, but may be
not be the same as a Common Command. When the name is the
same as a SCPI command, the macro rather than the command will
be executed when the name is received if macro usage is enabled.
The SCPI command will be executed if macro usage is disabled.
Executable when initiated: Yes
Coupled command: No
Related Commands:
*RST Condition: none; macro defintions are unaffected
Power-On Condition: no macros are defined
Define macro to restart waveform
*DMC RESTART,#19ABOR;INIT
t the enable masks of any of the Status Registers.
STATus:PRESet
>,< data > creates a macro with the specified name and assigns
Parameter
Type
1 through 12 characters
block data any valid command sequence
,
*EMC *GMC
HP E1340A Command Reference
Range of
Values
, ,
*LMC *RMC
Define macro
*CLS
Default
Units
none
none
189