[:Level][:Immediate]:Offset; Offset - HP E1340A User Manual

[SOURce:]VOLTage[:LEVel][:IMMediate]:OFFSet
[:LEVel][:IMMediate]:

OFFSet

Parameters
Comments
Example
180 HP E1340A Command Reference
[SOURce:]VOLTage[:LEVel][:IMMediate]:OFFSet <
output offset voltage for all waveform shapes except DC. Output offset
amplitude is programmed in volts.
Parameter Parameter
Name Type
offset
numeric
DC Output: When a matched load has been specified, MINimum selects
-5.12 V; MAXimum selects +5.11750 V.
Arbitrary Waveform, Ramp, Sine, Square, and Triangle Outputs:
When a matched load has been specified, MINimum selects the greater of
(-6.0 V + output amplitude value) and -5.12 V, rounded down if needed to a
multiple of 2.5 mV; MAXimum selects the lesser of (+6.0 V - output amplitude
value) and +5.1175 V, again rounded down.
For all waveform shapes, when an open circuit load has been specified, double
all the voltage values above.
The above values bound the legal range for
Related Commands:
SOURce:VOLTage:LEVEL:IMMediate:AMPLitude
Executable when initiated: Query form only
Coupled command: Yes
*RST Condition:
Setting offset voltage
VOLT:OFFS 3
Range of
Values
see below |
MINimum | MAXimum
offset .
SOURce:VOLTage:LEVel:IMMediate:OFFSet 0 V
Set offset voltage to 3 volts
offset > sets the
Default
Units
volts
Chapter 7