[:Segment]:Voltage; Voltage - HP E1340A User Manual

[:SEGMent]:VOLTage

Parameters
Comments
Example
Chapter 7
[SOURce:]LIST[:SEGMent]:VOLTage <
output voltage points that constitute a waveform segment. The points are
specified in terms of volts.
The voltage_list may be either a comma-separated list of voltage values or
an IEEE-488.2 definite or indefinite length block containing the values in
IEEE-754 64-bit floating-point format.
The legal range for voltage values is specified by the
SOURce:VOLTage:LEVel:IMMediate:AMPLitude
are volts.
and
MINimum MAXimum
If block format is used, the most significant byte of each voltage
value must be sent first.
The voltage point list length must contain exactly 4096 points.
The voltage values specified by this command are scaled relative to
the full-scale output voltage specified by
SOURce:VOLTage:LEVel:IMMediate:AMPLitude
the voltage point list is created. Subsequently changing the full-scale
output voltage will change the actual output voltages that are
generated.
Waveform segment contents are unspecified at power-on and must
be loaded before the segment may be output.
Executable when initiated: No
Coupled command: No
Related Commands:
SOURce:VOLTage:LEVel:IMMediate:AMPLitude
*RST Condition: unaffected
Power-On Condition: waveform segment contents are unspecified
Defining a waveform segment voltage point list
LIST:SEL B
LIST:VOLT .5,1,.5,0,-.5,......,-1
[SOURce:]LIST[:SEGMent]:VOLTage
voltage_list
command. Default units
cannot be used with this command.
SOURce:LIST:SEGMent:VOLTage:DAC
Select waveform segment B
Define 4096 waveform voltages
HP E1340A Command Reference
> defines the series of
in effect at the time
,
163