Rmc; Rst; Sav - HP E1340A User Manual

Arbitrary function generator
Hide thumbs Also See for E1340A:
Table of Contents

Advertisement

*RMC

*RMC
Comments

*RST

Comments

*SAV

194
HP E1340A Command Reference
*RMC <
name
>
purges only the specified macro definition.
NOTE: At printing time,
revision and re-designation of IEEE-488.2.
Use the
command to purge all macro definitions in one
*PMC
command.
Executable when initiated: Yes
Coupled command: No
Related commands:
*RST Condition: none
resets the HP E1340A as follows:
*RST
Sets all commands to their
Aborts all pending operations including waveform generation.
Sets all stored (
*SAV
*RST
does not affect:
-
The state of VXIbus word serial protocol
-
The output queue
-
The Service Request Enable Register
-
The Standard Event Status Enable Register
-
The enable masks for the Operation Status and Questionable Signal
Registers
-
Calibration data
-
Waveform segment definitions
Executable when initiated: Yes
Coupled command: No
*RST Condition: none
*SAV <
number
>
stores the current programming state into one of the 10
possible stored state areas. Number indicates which of the stored state areas
should be used.
This command stores the states of all commands affected by
exceptions the
SOURce:LIST
definitions, the
STATus
state.
CALibration:STATe:AC
is a command proposed and accepted for a
*RMC
,
*DMC
*PMC
*RST
state.
) states to the same state as the
commands, including waveform segment
subsystem commands, and the
*RST
state.
*RST
. Notable
Chapter 7

Advertisement

Table of Contents
loading

Table of Contents