Using Minimum And Maximum Parameters - HP E1340A User Manual

Using MINimum
and MAXimum
Parameters
53 Generating Standard Waveforms with the HP E1340A
The W, DBM, and DBMW unit types references the amplitude levels
to the 50 output load value. Thus, the W, DBM, and DBMW
values are meaningless and not available when selecting an open
circuit load.
You can execute many commands (like
using the MINimum or MAXimum
However, MIN and MAX
values when received using the values of other commands in effect at that
time. The values of other commands affecting the
computation are subsequently changed, but the already computed
values do not change.
MAX
Thus, if a group of coupled commands are sent where the
MAXimum parameters conflict with the current AFG setting, the AFG
generates an error. This happens even though the commands that follow
may set the AFG to a state that does not conflict with the
parameters.
MAXimum
For best results, use values in the commands and do not use the
and MAXimum parameters.
[SOURce:]FREQuency[:CW|:FIXed]
parameters instead of a number value.
are internally converted immediately to numeric
and
MIN MAX
MIN and
and
MINimum
and
MINimum
MINimum
Chapter 2
)