Operation |Questionable :Ptransition; Preset; Ptransition - HP E1340A User Manual

STATus:OPERation |QUEStionable :PTRansition
:OPERation
|QUEStionable

:PTRansition

Parameters
Comments
Example

:PRESet

Comments
Example
184 HP E1340A Command Reference
STATus:OPERation|QUEStionable:PTRansition <
positive transition mask. For each bit unmasked, a 0-to-1 transition of that
bit in the associated Condition Register will set the same bit in the
associated Event Register.
Parameter Parameter
Name Type
unmask numeric or
non-decimal
numeric
The non-decimal numeric forms are the #H, #Q, or #B formats specified by
IEEE-488.2.
Executable when initiated: Yes
Coupling group: none
Related commands:
*RST Condition: unaffected
Power-on Condition:
STATUS:OPERation|QUEStionable:PTRansition 32767
Setting the Operation Register positive transition mask
STAT:OPER:PTR #H0100
initializes the Enable Registers and transition masks for
STATus:PRESet
the Operation and Questionable Signal Status Registers and sets
STATus:OPC:INITiate ON
are set to 0, the negative transition masks are set to 0, and the positive
transition masks are set to 32767.
Executable when initiated: Yes
Coupling group: none
Related commands:
*RST Condition: none
Presetting the STATus subsystem
STAT:PRES
Range of
Values
0 through +32767
,
STATus subsystem *SRE
Set event bit when initiated
condition is set
. For both Status Registers, the Enable Registers
STATus subsystem , *SRE
Preset STATus subsystem
unmask > sets the
Default
Units
none
,
*STB?
, *STB?
Chapter 7