Arm; [:Start][:Layer[1]] :Count - HP E1340A User Manual

ARM

Subsystem Syntax
[:STARt][:LAYer[1]]
:COUNt
Comments
Example
Chapter 7
The ARM subsystem operates with the
starting of waveform output as follows:
The source and slope for arming (starting) waveform generation.
The number of waveform start arms the HP E1340A will accept
before the trigger system returns to the idle state.
The number of repetitions of a waveform that will be output for each
start arm accepted.
ARM
[:STARt|SEQuence[1]]
[:LAYer[1]]
:COUNt <
:LAYer2
:COUNt <
:SLOPe <
:SOURce <
ARM[:STARt][:LAYer[1]]:COUNt <
waveform repetitions to be output for each start arm accepted.
Parameter Parameter
Name Type
number numeric
Ramp, Sine, Square, and Triangle Outputs: MINimum selects 1 repetition;
MAXimum selects 65534 repetitions. 9.9E+37 is equivalent to INFinity.
Arbitrary Waveform Output: MINimum selects 1 repetition. If
SOURce:FUNCtion:USER A | B | C | D | HOP_AB is selected, MAXimum
selects 65534 repetitions. If SOURce:FUNCtion:USER AB is selected,
MAXimum selects 32767 repetitions. If SOURce:FUNCtion:USER ABCD is
selected, MAXimum selects 16383 repetitions.
Use the
ABORt
ARM:STARt:LAYer1:COUNt
Executable when initiated: Query form only
Coupled command: Yes
Related Commands:
*RST Condition:
Setting waveform repetitions per arm
ARM:COUN 10
ARM[:STARt][:LAYer[1]] :COUNt
TRIGger
number
>
number >
edge
>
source >
number selects the number of
>
Range of
Values
see below |
MINimum | MAXimum
command to terminate the output when
is set to
INFinity
ABORt
ARM:STARt:LAYer1:COUNt INFinity
Set 10 repetitions/arm
HP E1340A Command Reference
subsystem to control the
Default
Units
none
.
139