Opc; Pmc; Rcl - HP E1340A User Manual

*OPC?

Comments

*PMC

Comments

*RCL

Parameters
Comments
Chapter 7
*OPC? causes the E1340A to wait for all pending operations to complete.
A single ASCII "1" is then placed in the output queue.
If
STATus:OPC:INITiate OFF
output queue when all commands received prior to the
executed. If ON is set,
before placing the "1" in the output queue. No other commands will be
executed until the "1" is placed in the output queue.
Executable when initiated: Yes
Coupled command: No
Related commands:
*RST Condition: none
purges all macro definitions.
*PMC
Use the
*RMC
Executable when initiated: Yes
Coupled command: No
Related commands:
*RST Condition: none
*RCL < number > restores a previously stored programming state from one
of the 10 possible stored state areas. Number indicates which of the stored
state areas should be used.
This command affects the same command settings as does
exceptions include the
segment definitions, the
CALibration:STATe:AC
Parameter Parameter
Name Type
number numeric
Executable when initiated: No
Coupled command: No
Related Commands:
*RST Condition: all saved states set to the same state as the
state
is set, the ASCII "1" will be placed in the
*OPC? waits for waveform generation to complete
,
*OPC *WAI
command to purge an single macro definition.
*DMC , *RMC
SOURce:LIST commands, including waveform
subsystem commands, and the
STATus
state.
Range of
Values
0 through 9
, ,
*LRN? *RST *SAV
HP E1340A Command Reference
*OPC?
*OPC? have been
*RST . Notable
Default
Units
none
*RST
193