Initiate; [:Immediate] - HP E1340A User Manual

INITiate[:IMMediate]

INITiate

Subsystem Syntax

[:IMMediate]

Comments
Example
146 HP E1340A Command Reference
The

INITiate

subsystem initiates the trigger subsystem and prepares the HP
E1340A for waveform generation. Once initiated, a start arm received from
the programmed arm source (
waveform output.
For frequency sweeping, the initial waveform frequency is the
frequency when
SOURce:SWEep:DIRection UP
frequency when
SOURce:SWEep:DIRection DOWN
INITiate

[:IMMediate]

INITiate[:IMMediate] initiates the trigger system. Waveform generation
begins immediately if
ARM:STARt:SOURce IMMediate
waveform generation begins when the first start arm is received. Only the
ABORt and *RST commands or a Device Clear will halt waveform
generation.
This command is an overlapped command as described by IEEE-488.2,
Section 12. The exit from the idle state caused by
cause its Pending Operation Flag to be set true. This Pending Operation
Flag will be set false when the idle state is re-entered.
Use the ABORt command to prematurely halt the waveform
generation and place the trigger system in the idle state.
Executing this command when
set, when
SOURce:ARBitrary:DAC:SOURce
with the trigger system not in the idle state generates error -123,
"Init ignored".
Executable when initiated: No
Coupled command: No
Related Commands:
ARM subsystem,
*RST Condition: The trigger system is in the idle state.
Initiating waveform generation
INIT
ARM:STARt:SOURce
[no query]
SOURce:FUNCtion:SHAPe DC
, ,
*OPC *OPC? *RST
TRIGger subsystem
Initiate waveform generation
command) starts the
STARt
is set, or the
STOP
is set.
is set; otherwise,
shall
INITiate:IMMediate
is
is not set to , or
INTernal
, ,
*WAI ABORt,
Chapter 7