Korg MMT microKORG XL+ Owner's Manual page 79

Synthesizer / vocoder
Table of Contents

Advertisement

17. GRAIN.SFT (Grain Shifter)
This effect samples extremely brief fragments of the sound at a specified
interval, and plays them as a loop. This is effective when used on external
input sounds that are constantly changing.
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
+
Right
LFO
DRY/WET ......................................................["DRY", 99:1...1:99, "WET"]
Sets the balance between the effect and dry sounds.
BPM SYNC (Duration Tempo Sync)..............................................[OFF, ON]
Specifies whether playback of the looped waveform will be synchronized.
If this is ON, the looped waveform will play in synchronization with the
tempo or MIDI clock.
TM RATIO
............. [BPM SYNC OFF: 000.5...400% (OVER)/BPM SYNC ON:
012.5...400% (OVER)]
This specifies the length of the looped waveform relative to the "DURA-
TION" value.
DURATION..................................................... [000...350ms, 1/64... 1/1]
Sets the duration of the grain.
The length of the waveform is determined by this setting and the "TimeRa-
tio" setting.
If "BPM SYNC" is OFF, this is set in msec units.
If "BPM SYNC" is ON, this is set as a timing resolution relative to the tempo
specified by the [TEMPO] knob or MIDI clock.
If the "DURATION" and "TM RATIO" settings exceed the limit, an
indication of
will appear for the "TM RATIO."
Dry / Wet
Grain Shifter
Sample Cycle
Dry / Wet
LFO SYNC (LFO Tempo Sync) .......................................................[OFF, ON]
Specifies whether the LFO cycle will be synchronized with the tempo speci-
fied by the [TEMPO] knob or MIDI clock.
 p. 66 "LFO SYNC (LFO Tempo Sync)"
LFO FREQ (LFO Frequency)
......................................... [0.01...100.0Hz]
If "LFO SYNC" is Off, this specifies the cycle at which the waveform is
switched in Hz units.
The waveform length specified by "DURATION" will play as a loop, and the
waveform will switch at each cycle of the LFO.
LFO Cycle
Duration
In
Out
If this parameter is assigned to "CTRL-1" or "CTRL-2," switching
"BPM SYNC" On will change the assignment to "SYNC.NOTE."
SYNC.NOTE (LFO Sync Note)
..............................................[8/1...1/64]
Sets the LFO frequency as a proportion of the tempo set by the [TEMPO]
knob.
This parameter will be displayed and can be set if "LFO SYNC" is ON.
NOTE
 p. 66 "SYNC.NOTE (LFO Sync Note)"
KEY SYNC (LFO KeySync).............................................................[OFF, ON]
Specifies whether the LFO will be reset by note-on.
 p. 67 "KEY SYNC (LFO KeySync)"
INI.PHASE (LFO Init Phase) .................................................. [000...180°]
Sets the starting location of the waveform.
This parameter will be displayed and can be set if "KEY SYNC" is ON.
NOTE
 p. 67 "INI.PHASE (LFO Init Phase)"
Effect guide
LFO Cycle /Duration
79

Advertisement

Table of Contents
loading

This manual is also suitable for:

Microkorg xl+

Table of Contents