Korg MMT microKORG XL+ Owner's Manual page 43

ROUTING.............................................[SINGLE, SERIAL, PARALLEL, INDIV]
Specifies the routing (connection) between filter 1 and filter 2.
SINGLE Only filter 1 is used.
Filter 1 and filter 2 are connected in series.
OSC1
SERIAL
OSC2
Noise
Filter 1 and filter 2 are connected in parallel.
OSC1
PARALLEL
OSC2
Noise
Filter 1 is applied to oscillator 1, and filter 2 is applied to oscillator
2 and noise.
OSC1
INDIV
OSC2
Noise
Filter1 Filter2
Filter1
Filter2
Filter1
Filter2
EG1 INT (EG1 Intensity/Filter1) ................................................ [–63...63]
This specifies how time-variant modulation from the EG1 will be applied to
the cutoff frequency.
Note on
Sustain Level
Attack Decay
Time
Time
The cutoff frequency will change over time according to the EG1 settings,
modifying the tone. For example, you can use this to create a sound that
gradually begins to brighten when you press the key, and then gradually
becomes darker.
"EG1 INT" parameter specifies the depth (sensitivity) to which the EG1 will
affect the cutoff frequency.
With a setting of 0, the EG1 will not affect the cutoff frequency.
Increasingly positive (+) settings will allow the EG1 to have a correspond-
ingly greater effect on the cutoff frequency.
Cutoff
Int=+32
Note on
Note off
Cutoff frequency
specified by
"Cutoff"
Parameter Guide
Note off
Release Time
Time
Int=+63
Note on
Note off
Int=0
Time
43