Korg MMT microKORG XL+ Owner's Manual page 50

microKORG XL+
EG1 INT2
KEY TRK2
ATTACK1
DECAY1
SUSTAIN1
RELEASE1
ATTACK2
DECAY2
SUSTAIN2
RELEASE2
ATTACK3
DECAY3
SUSTAIN3
RELEASE3
P.INT1
P.INT2
P.INT3
P.INT4
P.INT5
P.INT6
INTENSTY (Patch Intensity) ......................................................[–63...63]
Specifies the depth of the effect produced by the modulation source.
With a setting of 0, there will be no modulation.
50
The FILTER2 page "EG1 INT".
The FILTER2 page "KEY TRK".
The EG1 page "ATTACK".
The EG1 page "DECAY".
The EG1 page "SUSTAIN".
The EG1 page "RELEASE".
The EG2 page "ATTACK".
The EG2 page "DECAY".
The EG2 page "SUSTAIN".
The EG2 page "RELEASE".
The EG3 page "ATTACK".
The EG3 page "DECAY".
The EG3 page "SUSTAIN".
The EG3 page "RELEASE".
The PATCH1 page "INTENSTY".
The PATCH2 page "INTENSTY".
The PATCH3 page "INTENSTY".
The PATCH4 page "INTENSTY".
The PATCH5 page "INTENSTY".
The PATCH6 page "INTENSTY".
Setting example for "SOURCE" and "DEST"
SOURCE [1] DEST [2]
The EG1 or EG2 will vary the pitch of the entire timbre over
EG1/EG2 PITCH
time.
The EG1 or EG2 will vary the pan over time. By setting two
EG1/EG2 PANPOT patches to "MOD INT" settings with the opposite (+/–) value
you can create more complex panning.
LFO 1/LFO 2 PITCH Vibrato will be applied at the LFO1 or LFO2 frequency.
CUTOFF Wah will be applied at the LFO1 or LFO2 frequency.
LFO 1/LFO 2
LFO 1/LFO 2 LEVEL Tremolo will be applied at the LFO1 or LFO2 frequency.
LFO 1/LFO 2 PANPOT Auto pan will be applied at the LFO1 or LFO2 frequency.
LEVEL
VELOCITY Velocity (keyboard playing strength) will affect the volume.
Keyboard position will gradually change the pan; lower
KEY TRK PANPOT
notes at the left, and higher notes at the right.
PITCH wheel operations or pitch bend change will move
PANPOT
P.BEND
the sound between left and right.
EQ (Equalizer)
Here you can adjust the equalizer settings. The equalizer is a shelving type.
EQ
+Gain
0dB
–Gain
Low EQ Frequency
LO FREQ (Low EQ Frequency).......................................... [0020...1000Hz]
Specifies the frequency of the low equalizer.
LO GAIN (Low EQ Gain)................................................[–15.0...+15.0dB]
Specifies the gain of the low equalizer.
Positive (+) values boost the region below the cutoff frequency.
3dB
3dB
High EQ Frequency