Korg MMT microKORG XL+ Owner's Manual page 58

microKORG XL+
POSITION .................................................................. [POST KBD, PRE TG]
Specifies the internal MIDI IN/OUT routing within the microKORG XL+.
This setting will affect the way in which MIDI data is transmitted and
received, and how the arpeggiator data is handled.
POST KBD: In this position, incoming MIDI data will be sent to the timbres
without being affected by the global or front panel transpose controls, and
will not trigger the arpeggiator. Data produced by the keyboard will be con-
verted according to the internal settings, routed through the arpeggiator
(arpeggiator notes are sent as MIDI data), and then sent to the MIDI OUT
connector.
GLOBAL: Master Transpose
Keyboard
GLOBAL: Velocity Curve
PRE TG: Incoming MIDI data will be affected by the global settings, and will
act as trigger notes for the arpeggiator. Data produced by the keyboard will
be sent to the MIDI OUT connector without being affected by any setting
other than OCTAVE [UP] [DOWN] button.
Keyboard
FRONT PANEL: Octave
MIDI OUT
KNOB.MODE ......................................................................[JUMP, CATCH]
Specifies the behavior of the front panel knobs when editing. ( p. 24)
JUMP: When you turn the knob, the parameter value will jump to the value
indicated by the knob, regardless of the stored value. Since this makes it
easy to hear the results while editing, we recommend that you use this set-
ting when editing.
CATCH: When you turn the knob, the parameter value will not change until
the knob position matches the stored value. We recommend that you use
this setting when you don't want the sound to change abruptly, such as dur-
ing a live performance.
58
MIDI IN
Arpeggiator Timbre 1
MIDI IN
GLOBAL: Master Transpose
GLOBAL: Velocity Curve
Timbre 2
Timbre 1 Arpeggiator
PROTECT ..................................................................................[OFF, ON]
This specifies whether internal memory will be protected.
OFF: You'll be able to write to internal memory.
ON: The following Write operations will be prohibited.
• Writing a program
• Loading the factory-set data
• Receiving a data dump
LCD.LIGHT (LCD Backlight mode) .......................................[OFF, AUTO, ON]
This switches the mode of the display backlight.
OFF: The backlight will not light.
AUTO: The backlight will light when you turn a knob or operate a switch.
After a time, the backlight will go dark.
Timbre 2
ON: The backlight will remain lit.
A. PWR.OFF (Auto Power Off)..................................... [DISABLE, 4 HOURS]
MIDI OUT
This function specifies whether the auto power off function is enabled or
disabled.
DISABLE: The auto power off function is disabled. The microKORG XL+
will not be automatically turned off.
4 HOURS: The microKORG XL+ will be automatically turned off if no user
input is received for approx. 4 hours.