Korg MMT microKORG XL+ Owner's Manual page 78

Synthesizer / vocoder
Table of Contents

Advertisement

microKORG XL+
Stereo In - Stereo Out
Left
Pre LPF
Pre LPF
Right
Fixed
Fixed Frequency
Note Offset, Fine
Note No.
Note (Key Follow)
LFO
DRY/WET ......................................................["DRY", 99:1...1:99, "WET"]
Sets the balance between the effect and dry sounds.
OSC MODE ..........................................................................[FIXED, NOTE]
Switching between specifying the oscillator frequency and using a note
number.
If this is set to NOTE, the oscillator frequency will track the note of the input
signal.
FIXD.FREQ (Fixed Frequency)
This parameter sets the oscillator frequency when "OSC MODE" is set to
FIXED.
If this parameter is assigned to "CTRL-1," or "CTRL-2," setting "OSC
MODE" to NOTE will switch the assignment to NOTE.OFST.
NOTE.OFST (Note Offset)
..................................................[–48...+48]
Sets the pitch difference from the original note in semitone steps when
"OSC MODE" is set to NOTE.
NOTE.FINE....................................................................... [–100...+100]
Sets the pitch difference from the original note in cent steps when "OSC
MODE" is set to NOTE.
By setting "NOTE.OFST" and "Note.Fine" so that the oscillator frequency
NOTE
will track the note that is input, you can produce a ring modulator effect
with a correct scale.
78
Dry / Wet
Ring Modulator
Ring Modulator
Dry / Wet
Oscillator
Pitch
OSC Mode
..................................... [0Hz...12.0kHz]
OSC WAVE (OSC Waveform) .................................... [SAW, TRIANGLE, SINE]
Selects the ocsillator waveform.
LFO INT (LFO Intensity)
................................................... [–63...+63]
Sets the depth of LFO modulation.
LFO SYNC (LFO Tempo Sync) .......................................................[OFF, ON]
Specifies whether the LFO cycle will be synchronized with the tempo speci-
fied by the [TEMPO] knob or MIDI clock.  p. 66 "LFO SYNC (LFO Tempo
Sync)"
LFO FREQ (LFO Frequency)
......................................... [0.01...100.0Hz]
Sets the LFO speed.  p. 66 "LFO FREQ (LFO Frequency)"
SYNC.NOTE (LFO Sync Note)
..............................................[8/1...1/64]
Sets the LFO frequency as a proportion of the tempo set by the [TEMPO]
knob.  p. 66 "SYNC.NOTE (LFO Sync Note)"
This parameter will be displayed and can be set if "LFO SYNC" is ON.
NOTE
LFO WAVE (LFO Waveform)................ [SAW, SQUARE, TRIANGLE, SINE, S&H]
Selects the LFO waveform.
 p. 66 "LFO WAVE (LFO Waveform)"
LFO.SHAPE ......................................................................... [–63...+63]
 p. 66 "LFO.SHAPE"
KEY SYNC (LFO KeySync).............................................................[OFF, ON]
Specifies whether the LFO will be reset by note-on.
 p. 67 "KEY SYNC (LFO KeySync)"
INI.PHASE (LFO Init Phase) .................................................. [000...180°]
Sets the starting location of the waveform.
This parameter will be displayed and can be set if "KEY SYNC" is ON.
NOTE
 p. 67 "INI.PHASE (LFO Init Phase)"
PRE LPF............................................................................... [000...127]
This parameter enables you to set the damping amount of the high range
sound input to the ring modulator. If the input sound contains lots of har-
monics, the effect may sound dirty. In this case, cut a certain amount of
high range.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Microkorg xl+

Table of Contents