Korg MMT microKORG XL+ Owner's Manual page 56

Synthesizer / vocoder
Table of Contents

Advertisement

microKORG XL+
RESO (Vocoder Resonance)..................................................... [000...127]
This specifies the amount of resonance for each of the carrier's sixteen
band-pass filters (the synthesis filter). Higher settings will boost the sound
in the region of the cutoff frequency.
FC.MOD.SRC (Fc Mode Source)............................................ [EG1...MIDI3]
Selects the modulation source that will be applied to the carrier band-pass
filter "FC.OFFSET."
The sources you can select are the same as the modulation sources for
NOTE
a virtual patch ( p. 49 "SOURCE"). However, EG1–3, LFO1–2, VE-
LOCITY, and KEY TRK will be the sources for timbre 1.
FC.MOD.INT (Fc Modulation Intensity).................................... [–63...+63]
Specifies the depth of the modulation that is applied to the carrier band-
pass filter (Synthesis filter) "FC.OFFSET."
EF.SENS (Envelope Follower Sens) ................................. [000...126, HOLD]
Specifies the sensitivity of the modulator's Envelope Followers. Lower set-
tings of this value will allow the attacks of the input signal to be detected
more rapidly.
If you set this to Hold, the character of the signal that is being input at that
moment will be held (Formant Freeze). Subsequently, the sound will retain
that character regardless of whether there is any input.
If you set this to Hold when there is no input signal present, there will
be no output even if an audio signal is subsequently input.
If you write the program with this value set to Hold, the program will
NOTE
memorize the response of the signal that was being held.
VC AMP (Vocoder Amp)
Here are the parameters for modulation and vocoder output.
VC LEVEL (Vocoder Level) ....................................................... [000...127]
Sets the output level of the vocoder.
DIRCT.LVL (Direct Level) ......................................................... [000...127]
Sets the volume level at which the modulatior input source will be output
directly (unaffected).
56
VC BAND (Vocoder Band)
These parameters specify the output level and panning (stereo position) for
each of the carrier's sixteen band-pass filters (the synthesis filter).
LEVEL1...16 ...........................................................................[000...127]
Specifies the output level of each band.
PAN1...16..............................................................................[L63...R63]
Specifies the panning of each band.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Microkorg xl+

Table of Contents