Korg MMT microKORG XL+ Owner's Manual page 69

Synthesizer / vocoder
Table of Contents

Advertisement

B1 FREQ (B1 Frequency).................................................. [20Hz...20kHz]
Sets the center frequency of Band 1.
B1 Q ..................................................................................[00.5...10.0]
Sets the bandwidth of Band 1.
B1 GAIN
............................................................... [–18.0...+18.0dB]
Sets the gain of Band 1.
B2 FREQ (B2 Frequency).................................................. [20Hz...20kHz]
Sets the center frequency of Band 2.
B2 Q ..................................................................................[00.5...10.0]
Sets the bandwidth of Band 2.
B2 GAIN
............................................................... [–18.0...+18.0dB]
Sets the gain of Band 2.
B3 FREQ (B3 Frequency).................................................. [20Hz...20kHz]
Sets the center frequency of Band 3.
B3 Q ..................................................................................[00.5...10.0]
Sets the bandwidth of Band 3.
B3 GAIN
............................................................... [–18.0...+18.0dB]
Sets the gain of Band 3.
OUT.LEVEL (Output Level)......................................................[000...127]
Sets the output level.
5. DECIMATR (Stereo Decimator)
This effect creates a rough sound like a cheap sampler by lowering the
sampling frequency and data bit length. You can also simulate noise unique
to a sampler (aliasing).
Stereo In - Stereo Out
Left
Pre LPF
Bit
Decimator
Sampling Frequency
LFO
Decimator
Pre LPF
Bit
Right
DRY/WET...................................................... ["DRY", 99:1...1:99, "WET"]
Sets the balance between the effect and dry sounds.
PRE LPF....................................................................................[OFF, ON]
Selects whether the harmonic noise caused by a decrease in sampling fre-
quency is generated or not.
If a sampler with a very low sampling frequency receives very high-pitched
sound that could not be heard during playback, it could generate pitch
noise that is unrelated to the original sound. Set "PRE LPF" to ON to pre-
vent this noise from being generated.
If you set the "FS" to about 3kHz and set "PRE LPF" to OFF, you can create
a sound like a ring modulator.
HI DAMP ...........................................................................[000...100%]
Sets the ratio of cut from the high range.
FS
........................................................................... [01.0...48.0kHz]
Sets the sampling frequency.
BIT
................................................................................. [04...24bit]
Sets the data bit length.
If you set a smaller value for the "BIT" parameter, the sound may be dis-
torted.
The volume level may also be changed. Use "OUT.LEVEL" to adjust the
NOTE
level.
OUT.LEVEL (Output Level) ..................................................... [000...127]
Sets the output level.
Effect guide
Dry / Wet
High Damp Output Level
High Damp Output Level
Dry / Wet
69

Advertisement

Table of Contents
loading

This manual is also suitable for:

Microkorg xl+

Table of Contents