Download Print this page

Advertisement

Stereo In - Stereo Out
Left
Delay
Delay
Right
LFO Spread
LFO
DRY/WET ......................................................["DRY", 99:1...1:99, "WET"]
Sets the balance between the effect and dry sounds.
BPM SYNC (Delay Time Tempo Sync)...........................................[OFF, ON]
 p. 70 "BPM SYNC (DelayTime Tempo Sync)"
TM RATIO
................................ [BPM SYNC OFF: 000.5...400.0% (OVER)
/BPM SYNC ON: 012.5...400.0% (OVER)]
 p. 70 "TM RATIO"
L DELAY, R DELAY (L, R Delay Time) ................ [000...1400ms, 1/64... 1/1]
 p. 70 "L DELAY, R DELAY (L, R Delay Time)"
FEEDBACK
.......................................................................[000...127]
 p. 71 "FEEDBACK"
MOD.DEPTH
.....................................................................[000...127]
Sets the depth of LFO modulation.
LFO FREQ (LFO Frequency)
........................................ [0.01...100.0Hz]
Sets the LFO speed. Increasing this value will result in a faster frequency.
LFO SPRD (LFO Spread)...................................................... [–180...180°]
Sets the phase difference between the left and right channels.
10. TAPE.ECHO
This effect simulates a tape echo unit. The distortion and tonal change typi-
cal of magnetic tape are also reproduced.
Dry / Wet
Feedback
Dry / Wet
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Left
Feedback
+
Tape
Saturation
Trim
Pre Tone
High / Low Damp
Wow Flutter
Right
DRY/WET...................................................... ["DRY", 99:1...1:99, "WET"]
Sets the balance between the effect and dry sounds.
BPM SYNC (DelayTime Tempo Sync)............................................[OFF, ON]
 p. 70 "BPM SYNC (DelayTime Tempo Sync)"
TM RATIO
................................[BPM SYNC OFF: 000.5...400.0% (OVER)
/BPM SYNC ON: 012.5...400.0% (OVER)]
 p. 70 "TM RATIO"
TAP1 DLY, TAP2 DLY (Tap1, Tap2 Delay Time)
........................................................... [0000...1400ms, 1/64... 1/1]
Sets the delay times for Tap1 and Tap2.
 p. 70 "L DELAY, R DELAY (L, R Delay Time)"
TAP1 LVL, TAP2 LVL(Tap1Level, Tap2 Level)
Sets the Tap1 output level and Tap2 output level.
FEEDBACK
....................................................................... [000...127]
Sets the Tap1 feedback amount.
HI DAMP ...........................................................................[000...100%]
Sets the damping amount in the high range.
LO DAMP ...........................................................................[000...100%]
Sets the damping amount in the low range.
TRIM................................................................................... [000...127]
Sets the input level.
Effect guide
Dry / Wet
Tap1 Level
Delay
Spread
Tap2 Level
Dry / Wet
........................ [000...127]
73

Advertisement

   Related Manuals for Korg MMT microKORG XL+

Comments to this Manuals

Symbols: 0
Latest comments:
  • remy Jan 26, 2017 12:50:
    The best manual in english!
    T​hanks