Korg MMT microKORG XL+ Owner's Manual page 72

Synthesizer / vocoder
Table of Contents

Advertisement

microKORG XL+
Stereo In - Stereo Out
Left
High Damp
Delay
Trim
Feedback
Delay
Trim
High Damp
Right
LFO
LFO Shape
DRY/WET ......................................................["DRY", 99:1...1:99, "WET"]
Sets the balance between the effect and dry sounds.
BPM SYNC (DelayTime Tempo Sync) ...........................................[OFF, ON]
 p. 70 "BPM SYNC (DelayTime Tempo Sync)"
TM RATIO
............................... [BPM SYNC OFF: 000.5...400.0% (OVER)/
BPM SYNC ON: 012.5...400.0% (OVER)]
 p. 70 "TM RATIO"
L DELAY, R DELAY (L, R Delay Time) ................ [000...1400ms, 1/64... 1/1]
 p. 70 "L DELAY, R DELAY (L, R Delay Time)"
FEEDBACK
.......................................................................[000...127]
 p. 71 "FEEDBACK"
MOD.DEPTH
.....................................................................[000...127]
Sets the depth of modulation.
LFO SYNC (LFO Tempo Sync) .......................................................[OFF, ON]
Specifies whether the LFO cycle will be synchronized with the tempo speci-
fied by the [TEMPO] knob or MIDI clock.
 p. 66 "LFO SYNC (LFO Tempo Sync)"
LFO FREQ (LFO Frequency)
........................................ [0.01...100.0Hz]
Sets the LFO speed.
 p. 66 "LFO FREQ (LFO Frequency)"
72
Dry / Wet
Pan
MOD Depth
Pan
Dry / Wet
LFO Spread
SYNC .NOTE (LFO Sync Note)
Sets the LFO frequency as a proportion of the tempo set by the [TEMPO]
knob.
This parameter will be displayed and can be set if "LFO Sync" is On.
NOTE
 p. 66 "SYNC.NOTE (LFO Sync Note)"
LFO WAVE (LFO Waveform)................ [SAW, SQUARE, TRIANGLE, SINE, S&H]
Selects the LFO waveform.
 p. 66 "LFO WAVE (LFO Waveform)"
LFO.SHAPE ......................................................................... [–63...+63]
 p. 66 "LFO.SHAPE"
KEY SYNC (LFO Key Sync) ............................................................[OFF, ON]
Specifies whether the LFO will be reset by note-on.
 p. 67 "KEY SYNC (LFO KeySync)"
INI.PHASE (LFO Init Phase) .................................................. [000...180°]
Sets the starting location of the waveform.
This parameter will be displayed and can be set if "KEY SYNC" is ON.
NOTE
 p. 67 "INI.PHASE (LFO Init Phase)"
LFO SPRD (LFO Spread)....................................................[–180...+180°]
Sets the phase difference between the left and right channels.
HI DAMP ...........................................................................[000...100%]
Sets the damping amount in the high range.
TRIM................................................................................... [000...127]
Sets the input level.
9. MOD.DELAY (Stereo Modulation Delay)
This is a stereo modulation delay.
............................................. [8/1...1/64]

Advertisement

Table of Contents
loading

This manual is also suitable for:

Microkorg xl+

Table of Contents