Rear Panel Tcc, Madi, And Fiber Connectors - Euphonix System 5 Installation Manual

E u p h o i n x System 5 Installation Guide
1
TCC IN/Out (DB15): Connect TCC IN to TCC control port at local unit.
1
Because the same unit is used at both ends, each has a TCC IN and a TCC OUT
connector. However, only the TCC IN is intended to be used at the local end and the
TCC OUT at the remote end.
FIBER SYNC/TCC TX/RX (ST Optical Connector): Connects local and re-
2
mote units. Connect local RX and TX to remote TX and RX, respectively.
Both connections are required for proper operation.
FIBER MADI TX/RX (ST Optical Connector): Connects local and remote
3
units. Connect local RX and TX to remote TX and RX, respectively. A single
connection can be used if MADI signals are only required for one direction.
4
MADI IN (BNC): MADI connection for signal being transmitted over fiber.
5
MADI OUT (BNC): MADI connection for signal being received from fiber.
2
Figure 3-44 Rear Panel TCC, MADI, and Fiber Connectors
Connect TCC OUT to TCC control port at remote unit.
3
4
85
System 5 Components
5