Troubleshooting Procedure Table (cont'd.)
Steps
Actions and Questions
18
Remove the clutch connector J19.
Check the following pins;
Is J19-1 <=> J19-2 less than 200Ω?
19
Does the Feed Gear in the MPT turn
when printing 1 sheet of paper?
20
Use service diagnostics to test the MPT
Feed Solenoid.
Does the solenoid actuate?
In the test, actuate the Interlock Switch.
21
Remove the MPT Feed Solenoid
connector J132;
Is J132-1 <=> J132-2 less than 100Ω?
22
Check the Front 2 Harness for continuity.
Error Messages and Codes
Yes
Replace the
Engine Control
Board, RRP 12.7.
Check parts for
damage or
obstructions in the
paper path.
Check the spring
and stopper of the
Feed Solenoid.
Go to step [22].
Replace the
Engine Control
Board, RRP 12.7
No
Replace the
MPT Turn
Clutch, RRP
.
3.13
Go to step [20].
Go to step [21].
Replace the
MPT Feed
Solenoid.
Replace Front 2
Harness
Assembly, PL
6.1.2.
39