Troubleshooting Procedures; Jam At Fuser - Xerox 6200B - Phaser Color Laser Printer Service Manual

Jam at Fuser

The printer's front panel displays "Jam at Fuser". The fuser has been removed,
reseated and locked into place. Any obstruction, media and debris has been removed
from the fuser paper path, printer power has been cycled and the error still appears.
Troubleshooting Reference Table
Applicable Parts
Fuser, PL 8.1.1
Exit Sensor/Actuator, PL 8.1.7
Motor Driver Board, PL 12.1.12
Troubleshooting Procedure Table
Steps Actions and Questions
1 Check the following for evidence of fault or
damage:
Exit Actuator & Sensor, PL 8.1.7
Fuser Assembly, PL 8.1.1
Front Cover, PL 1.1.2
Chute Assembly In, PL 5.1.1
Transfer Roller, PL 8.1.12
Imaging Unit, PL 9.1.3
2 Remove the Fuser and check for broken or
bent pins.
3 Use service diagnostics to test the Exit
Sensor.
Does the sensor function correctly?
4 Does an error occur after the Fuser
Assembly has been replaced?
5 Insert a sheet of paper into the Fuser
Assembly.
Verify the voltage on the Fuser Harness
P138-3 <=> P138-2 is 0VDC.
6 Check all pins on the FSR 2 (Fuser)
Harness Assembly (PL5.1.10 ) for
continuity.
7 Check all pins on the Front 1A Harness
Assembly for continuity.
8 If possible print one sheet of paper.
Does the Fuser Motor Turn?
Inspect the gears for damage.
Error Messages and Codes
Wiring and Plug/Jack Map References
"Drive Section" on page 355
"Fuser Assembly" on page 358
"Map 1" on page 345
Yes
Replace the
part(s) concerned.
Replace the parts
concerned.
Go to step [8].
Go to step [5].
Go to step [7].
Go to step [7].
Go to step [8].
Replace the
gear(s) if
defective.
Jam F
No
Go to step [2].
Go to step [3].
Replace the
Fuser Assembly.
Go to step [4]
Complete.
Go to step [6].
Replace the
Assembly,
Harness FSR 2
PL 5.1.9.
Replace the
Assembly, Front
1A, PL 13.1.7.
Go to step [9].
31