Caution: The yellow and gray harnesses on the EEPROM Board
contain the same number of pins, but are NOT
interchangeable. Make sure P/J144 (yellow) is connected
on the top and the P/J145 (gray) is connected to the
bottom.
9.
Free the harness in step 6 from the bottom portion of the Housing Assembly Bias.
10.On the right side of the printer, disconnect P/J52 and P/J50 from the Motor Driver
Board and disconnect P/J162 from the Low-Voltage Power Supply.
11.Remove 1 screw securing the Fuser ground wire (right side) and move out of the
way.
12.Free the wiring harness on the Fuser Drive Assembly from the clamp on the Main
Drive Assembly.
13.Free the wiring harness on the Fuser 2 Harness Assembly from the hook of the
housing on the right side of the printer.
FRU Disassembly - Removal and Replacement Procedures
S6200-113
173