Tray [2] [3] Paper Is Low - Xerox 6200B - Phaser Color Laser Printer Service Manual

Tray [2] [3] Paper is Low

The printers front panel displays "Tray 2 or 3 Paper is Low" when the paper tray is
full of paper. The tray has been inspected for defects. Printer power has been cycled
and the error still appears
In the following procedures, diagnose the part that correlates directly to the Tray
receiving the error.
Troubleshooting Reference Table
Applicable Parts
Low Paper Sensor, PL 14.5.7
Low Paper Lever, PL 14.5.8
Troubleshooting Procedures Table
Steps Actions and Questions
1 Fill the tray with paper.
Does the error occur if the tray is full?
2 Check the following for evidence of fault or
damage:
Low Paper Sensor; PL 14.5.7
Low Paper Lever, PL 14.5.8
3 Use service diagnostics to test the
Tray [2] [3] Low Paper Sensor.
Do the sensor and actuator function
properly?
4 Does the printer function correctly after
replacing the Circuit Board HCF?
5 Troubleshoot using the Paper Tray [2] [3]
wiring diagrams.
Does the printer function correctly after
replacing any defective parts?
62
Wiring and Plug/Jack Map References
"Paper Tray 2" on page 366
"Paper Tray 3" on page 367
Phaser 6200 Color Laser Printer - Service Manual
Yes
Go to step [2].
Replace the parts
concerned
Replace the
Engine Control
Board,
RRP 12.7.
Complete
Complete
No
Complete
Go to step [3].
Go to step [4].
Go to step [5].
Replace the
Engine Control
Board,
RRP 12.7.