Xerox 6200B - Phaser Color Laser Printer Service Manual page 63

Misfeed at Tray 3
The printers front panel displays "Misfeed at Tray 3" indicating a paper misfeed has
occurred in the printer. Tray 3 is free of defects and correctly installed in the printer.
Any obstruction, media and debris has been removed from the paper path and there is
adequate paper in the paper tray. Printer power has been cycled and the error still
displays.
Troubleshooting Reference Table
Applicable Parts
Paper Pick Roller Kit, PL 14.4.3
Paper Feed Roller Kit, PL 14.1.2
HCF Paper Pick Assembly, PL 14.4.1
Troubleshooting Procedure Table
Steps Actions and Questions
1 Does the printer feed paper correctly from
Tray 1?
2 Does the HCF Motor run when printing one
sheet?
3 Use service diagnostics to test the HCF
Motor.
Does the HCF motor function correctly?
4 Verify the voltage between P/J84-3 <=>
P/J81-1 on the Lower Feeder Circuit Board is
+24 VDC
5 Verify the voltage between P/J81-2 <=>
P/J81-1 on the Lower Feeder Circuit Board
HCF is +24 VDC.
6 Verify the connector between the HCF and
the printer is connected properly and not
damaged.
7 Does the error recur after the HCF Motor has
been replaced with a new one?
8 Perform steps 1 through 3 in RRP 14.3. Open
and close the front door.
Observe the Turn Roller.
Dose the Turn Roller turn while the machine
is warming up?
9 Does the Tray 3 Turn Clutch Assembly
function correctly when feeding 1 sheet of
paper?
Error Messages and Codes
Wiring and Plug/Jack Map References
"Paper Tray 3" on page 367
"Paper Feed" on page 362
Yes
Go to step [2].
Go to step [10].
Replace the
Engine Control
Board,
RRP 12.7.
Go to step [7].
Replace the
Lower Feeder
Circuit Board,
PL 14.5.1.
Replace the
damaged part.
Go to step [8].
Go to step [12].
Go to step [14].
Jam T3
No
See "Misfeed at
Tray 1 Jam T1"
on page 40.
Go to step [3].
Go to step [4].
Go to step [5].
Go to step [6]
Go to step [7].
Complete
Go to step [9].
Go to step [10].
45