Xerox 6200B - Phaser Color Laser Printer Service Manual page 82

Tray 1 Empty, Load Paper
The printer's front panel displays "Tray 1 Empty, Load Paper" when the tray is full.
The tray 1 cavity is free of debris and obstructions. The tray is free of defects and is
properly positioned within the printer. Printer power has been cycled and the message
still appears.
Troubleshooting Reference Table
Applicable Parts
No Paper Sensor, PL 3.3.4
Link Actuator, PL 3.3.6
No Paper Actuator, PL 3.3.5
Troubleshooting Procedure Table
Steps Actions and Questions
1 Fill Tray 1.
Does the error occur even if the tray is
full?
2 Check the following for evidence of fault
or damage:
No Paper Sensor, PL 3.3.4
No Paper Actuator, PL 3.3.5
3 Use service diagnostics to test the Tray 1
No Paper Sensor
Does the sensor function correctly?
4 Does the printer function correctly after
replacing the Motor Driver Board?
5 Troubleshoot using the wiring diagram
"Paper Tray 1" on page 354.
Does the printer function correctly after
replacing any defective parts?
64
Wiring and Plug/Jack Map References
"Paper Tray 1" on page 354
Yes
Go to step [2].
Replace the parts
concerned.
Replace Engine
Control Board,
RRP 12.7.
Complete
Complete
Phaser 6200 Color Laser Printer - Service Manual
No
Complete
Go to step [3].
Go to step [4].
Go to step [5].
Replace the
Engine Control
Board, RRP 12.7.