Pulsed Gpi Switching; System-Wide Gpi Relay And Speaker Mutes - Euphonix MixView CS3000 Software Manual

Section 10: MX464
Pulsed GPI
Switching
Setup
F1
System-wide GPI
Relay and Speaker
mutes
SIDE NOTE:
Be aware that changing the
init state, active state or pulse
width timing of a relay or
speaker mute always resets
the relay/speaker mute
parameters back to their
initialized states.
10 - 70
To sum Ext 1 with all other Master Monitor settings, set the Mon A, B or C
parameter to "
To add Ext 1 and cancel all cur
or C parameter to "i".
To shut of f all Master Monitor settings, set the Mon A, B or C parameter to
"k".
4
Mon A
Mon B 5
6
Mon C
7
Mi A B C
INCR ( ) 8
GPI control has been enhanced in v3.0 software through the addition of the
pulsed GPI control parameters. Each GPI relay can be set for pulsed (momen-
tary) operation. Additionally
both fader movement directions and for selectable timing intervals (pulse
width) from 20mS - 2.54s. From the top level SmartDisplay menu, press [
twice to display the GPI menu and screen:
Snap System Grps
F2 F3 F4
R1 OPEN
F1
MX464 GPI relays and speaker mutes are now configured 'system-wide' and
only the assignment to faders is title-specific. The initialize (reset) state,
action state and pulse width timing of a relay or speaker mute do not change
when a title is loaded or saved.
This system-wide data is stor
dependent on the PC. Once set, these settings should never need attention
unless the lithium cell fails or the DSC module is replaced.
Euphonix CS3000/2000 MixView 3.0 Software Supplement
".
rent Master Monitor settings, set the Mon A, B
Selected parameters appear to the right of the alpha
display . Pr essing the [ M A B C] key toggles between the
standard MX464 monitor displays while continuing to
show the assignments in the alpha display
Toggles the Monitor
Assignable key display
, this behavior can be set to operate in either or
File F-Link
F1
— — CLSD
F2 F3 F4
ed in the DSC' s batter y-backed RAM and is not
.
GPI MIDI
F2 F3 F4
F3]