Metering Presets; Mt Bus To Out3 - Euphonix MixView CS3000 Software Manual

SIDE NOTE:
Any combination of sources you
cannot monitor directly can be
monitored using the Combiner.

Metering Presets

7 8 9
4 5 6
1 2 3

MT Bus to Out3

16CH->
F1
Euphonix CS3000/2000 MixView 3.0 Software Supplement
The following list details available selections:
LEFT METER:
Aud:
Lvl:
RIGHT METER:
Aud:
Lvl:
An asterisk (*) indicates that choice is available only for F Rev channel hard-
ware.
Metering presets allow you to easily configure meter pairs. Pressing any
numeral on the DSC Numeric Keypad recalls these Meter selection presets.
Following is a list of the numeric presets available:
KEY
0 —
1 —
2 —
3 —
4 —
5 —
6 —
7 —
8 —
9 —
For certain signal routing situations, the MT bus can be sent from Out3. This is
useful when the Dir 1 & Dir 2 connectors must be used to feed a 2/channel
Cube for example. Another example may be to obtain a stereo post fader
direct feed using Dir 1/2.
To set the Out3/MT routing, press the channel attention key at the top of the
channel, [F2] (OUTs) and then [F4] (OUT3):
OUTs METER Route
F2 F3 F4
16CH->OUT3
F1
Section 7: Channel Function Enhancements
M1, L1*, L3, CMB*, MT, LFL, UFL, OFF
UF, UP, A, C, M1, OFF, LF, LP, B, D, M2
M2, L2*, L4, MT*, CMB*, LFR, UFR, OFF
LF, LP, B, D, M2, OFF, UF, UP, A, C, M1
LEFT METER:
E Rev F Rev
Aud:OFF Aud:OFF
Aud:M1 Aud:M1
Aud:L3 Aud:L1
Aud:MT Aud:L3
Aud:LFL Aud:CMB
Aud:UFL Aud:MT
Lvl:UF Aud:LFL
Lvl:M1 Aud:UFL
- - - Lvl:UF
- - - Lvl:M1
16CH-> OUT1
F1
?
F2 F3 F4
RIGHT METER:
E Rev F Rev
Aud:OFF Aud:OFF
Aud:M2 Aud:M2
Aud:L4 Aud:L2
Aud:L4 Aud:L4
Aud:LFR Aud:MT
Aud:UFR Aud:CMB
Lvl:LF Aud:LFR
Lvl:M2 Aud:UFR
- - - Lvl:LF
- - - Lvl:M2
OUT2 OUT3
F2 F3 F4
7 - 57