Touch On/Off; Release On/Off - Euphonix MixView CS3000 Software Manual

Touch ON/OFF

SIDE NOTE:
Press the DSC [ Punch] key
to quickly access the settings
for Touch & Release from
the top-level Punch menu.
Pressing [F2] toggles the Touch option ON/OFF:

Release ON/OFF

Pressing [F4] toggles the Release option ON/OFF:
Euphonix CS3000/2000 MixView 3.0 Software Supplement
The next option we will look at is Touch:On/OFF. This preference is located in
the Touch/Release menu. Press [F3] to get the Touch/Release menu.
Moving Faders Menu
Touch/Release Menu
The Touch option globally activates the touch-sensitive punch-in feature for all
moving faders in the console. You can begin writing (punch-in) fader automa-
tion data simply by touching the fader cap at the desired time to make any
necessary changes.
On any initial automation pass, automation punch-in is accomplished by
pressing the appropriate fader's punch (attention) key, just as with standard
non-motorized automation faders. Any subsequent punch-ins, however, can be
accomplished simply by touching the fader cap. To think of it another way,
fader automation data must exist in order for the touch punch feature to be
active. This is called First Punch Manual and is explained in detail later in
this section. The console default is Touch:ON.
Setting the Touch option OFF disables touch punch-in for all faders while still
allowing manual punch-in, protecting your mix from inadvertent punch-ins.
The Release option affects what happens when you release the fader. It
allows you to globally configure all faders to either stop writing (punch-out) or
continue writing fader automation data when you take your finger off the fader
cap.
With Release ON, the fader punches out of automation write mode as soon as
you remove your finger from the fader cap.
Motors:ON Touch
F1 F2
Touch:ON
F1 F2
Touch:OFF
F1 F2
Touch:ON
F1 F2
Section 6: Moving Faders
Slvs
F3 F4
Release:ON
F3 F4
Release:OFF
F3 F4
Release:OFF
F3 F4
6 - 43