GE Monogram ZGP484NGRSS Owner's Manual page 39

The Problem Solver
Professional All-Gas Range
PROBLEM
TIMER DOES NOT
WORK
OVEN TEMPERATURE
TOO HOT OR TOO
COLD
POSSIBLE CAUSE
........ ",4
The"_t'i"m'er'cannot be used while the oven is self-cleaning.
DISPLAY GOES BLANK
UNABLE TO GET THE
DISPLAY TO SHOW
"SF"
........................ j,,j,,,,,,,,,,, , ,, , ,
Oven thermostat needs adjustment. See the Oven thermostat adjustment
section.
OVEN DOOR WILL NOT The oven is too hot. Allow the oven to cool betow locking temperature.
OPEN AFTER A CLEAN
CYCLE
"Err turn SurFACE
'Se'if'-"ciean
is in progress and the Cooktop Lockou'i"1_ec_tureis activated. No
BurnErS OFF" SCROLLS surface cooking is permitted during the self-clean operation. Wait until the self-
IN THE DISPLAY cleaning operation has been completed.
,,, ,, , , ,, , ........
"CLOSE door" The self-clean cycle has been selected but the door is not closed.
SCROLLS IN THE Close the oven door. The I_ symbol will appear in the display
DISPLAY
I_ IS ON WHEN YOU The oven door is locked because the temperature inside the oven has not
WANT TO COOK dropped below the unlocking temperature, Turn the Oven Mode Selector and
the Temperature knobs to OFF. Allow the oven to coot.
,,, , ,, ,,
F- AND A NUMBER The oven has a function error code. Turn the Oven Mode Selector and the
FLASH IN THE DISPLAY Temperature knobs to OFF. Allow the oven to cool for one hour, Put the oven
back into operation.
Disconnect all power to the oven for 30 seconds and then reconnect power, if
the function error code repeats, call for service.
,,,, ,,, ,, ,,, ,
The display is blank when the oven or timer is not in use.
A fuse in your home may be blown or the circuit breaker tripped, Replace the
i fuse or reset the circuit breaker.
The TIMER and the MINI-KNOB buttons must be pushed at the same time and
held for/4 seconds.
"PROBE" APPEARS IN
THE DISPLAY
t.................
] SHOWS IN DISPLAY
POWER OUTAGE
Tllis i Sremindingyou to enterO probe tern'pe'rature after pluggingin'ihe probe.
Enter a probe temperature
,,, . ...... ,, ,
The Sabbath mode has been selected.
STEAM FROM THE
VENT
If the oven was in use during o power outage or surge, the oven must be reset.
Turn the Temperature knob and the Oven Mode Selector to OFF, Reset the
controls to begin again.
When using the convection mode, it is normal to see steam coming out of the
oven vent. As the number of racks or amount of food being cooked increases,
the amount of visible steam will increase.
BURNING OR OILY This is normal in o new oven and will disappear in time.
ODOR
EMITTING FROM
TH E VENT
STRONG ODOR This is temporary. An odor from the insulation around the inside of the oven is
normal for the first few times the oven is used.
FAN NOISE A cooling fan or a convection fan (depending on the function you ore using)
may turn on. This is normal. The cooling fan will turn on to coot internal parts. It
may run after the oven is turned off. The convection fan may cycle on and off
until the function is over or the door is opened.
39