GE Monogram ZGP484NGRSS Owner's Manual page 38

The Problem Solver
Professional All-Gas Range
Review the
troubleshooting
tips on the
following pages
first and you
may not need
to carl for
service.
PROBLEM
OVENWILL NOT
WORK
SURFACE BURNERS
LIGHT BUT OVENDOES
NOT
OVEN LIGHTIS} DO NOT
WORK
,,,, ,,,,,
FOOD DOES NOT BAKE
OR ROAST PROPERLY
,,,,,,,,,,, ,,,,,,, , .....
FOOD DOESNOT BROIL
PROPERLY
OVENWILL NOT SELF
CLEAN
CRACKING OR "POPPING
SOUND DURING
CLEANING
EXCESSIVE SMOKING
OCCURS DURING
CLEANING
OVEN NOT CLEAN AFTER
A CLEAN CYCLE
OVENRACKS ARE
DIFFICULTTO SLIDE
POSSIBLE CAUSE
A fuse in your homemay be blown""or the circuit breakertripped.
Theovencontrolsare not properlyset.
Theovencontrolsare set for cleaning.If necessary, allow the ovento cool;thenopen
the door.
Hake sure the Oven Node Selector is set to BAKEand the Temperature knob is set to u
temperature.
The oven gas shut-off vatve may have accidentally been moved during cleaning or
moving.
TEelight bulb is"defective. Replace the bulb.
The oven is self-cleaning or the Sabbath feature is set. The oven lights do not come on
during self-cleaning or if the Sabbath feature is set.
The oven is set for Proof mode. The lights cycle on and off as necessary to maintain
Proof temperature.
The oven controls are improperly set. Seethe Baking or Roasting section.
Oven not preheated for a long enough time; wait for the oven to signal preheat.
Incorrect cookware or cookware of improper size being used. See Baking Tips.
Racksin the wrong position. Seethe Baking or Roasting section,
Use o foii tent to slow down browning during roosting,
Oven theE,mostatneeds o.,d.j.us!ment, Seethe O,ve,n thermost,o,!,,,odjustmen! section.
This model is designed for closed door broiling only, Close the door. Always broil with the
door closed.
The oven controls are not set at BROIL.Seethe Broiling section.
The probe is plugged into the outlet in the oven. Remove the probe from the oven.
Improper rack position being used.
Cookware is not suited for broiling, Usethe broiling pan and grid that came with your
oven,
Aluminum foil used on the broiling pan and grid has not been fitted properly and slit as
recommended.
The oven temperature is too high to set a self-clean operation.
Allow the oven to cool below the locking temperature and reset the controls.
The controls are not properly set. Seethe Self-Ciea, n !ng Oven section.
This is normal. This is the sound of the metal heating and cooling during both the
cooking and cleaning functions.
The oven is hec_'"vily soiied. Turn the Oven Node Selector and the Temperature"knobs to
OFF.Open the windows to rid the room of smoke. Wait until the locked door indicator
light goes off. Wipe up excess soil and reset the cleon cycle.
IThe oven was heavily soiled. Cleon up heavy spillovers before starting the cteon cycle.'
Heoviry soiled ovens may need to self-cleon again.
Oven is connected to a 208V electricaJ supply. Set your cleaning time for 5 hours.
The oven controls are not properly set. Seethe Self-Cleaning Oven section.
The racks were cleaned in the self<leon cycle and now need periodic lubrication.
Do not spray with a cooking spray or other lubricant sprays. SeeFull extension oven
racks in the Care and Cleaning section.
38