Oven Lights - GE Monogram ZGP484NGRSS Owner's Manual

Care and Cleaning
Professional All-Gas Range
Oven lights
32
A CAUTION:
Beforereplacing a bulb,
disconnect electrical power to the oven at the
main fuse or circuit breaker panel.
Eachoven is equipped with halogen light columns
located on the side walls of the oven. The_ights
come on when the door is opened or when the
oven is in a cooking cycle.
Eachlight assembly consistsof a removable light
coverwith two locking clipsand a lightcompartment
with three halogen bulbs.
Besure to let the light cover and bulb cool
completely.Foryour safety, do not touch a
hot bulb with bare hands or a damp cloth.
TO remove:
1. Removethe racksfrom the oven.See the
Ful!extensionoven rackssection.
2. Usinga 7/16" nutdriver,remove the four nuts
holdin,it[he rack supportsto the ovej[ntlwallj_
3. Removethe glass light cover by puIIing its buck
edge out and rolling it toward you. Do not
remove any screws.
l; [tl
4, Usinggloves or a dry cloth, remove the
burned-out light bulb by pullin! it straight out.
To replace:
Usea new 120-volt Halogen
bulb, with G8 pins,not to
exceed 25 watts.
Replacementbulbsmay be purchasedby calling
800.626.2002.OrderPart Number WB25T1006&
NOTE:Higherwattagebulbs willdamageyour oven.
Usinggloves or a dry cloth, remove the bulb
from its packaging.Do not touch the bulb with
bare fingers. Oil from bare fingers may cause hot
spots on the glass surface and lead to premature
failure of the bulb,If you do touch the gloss,cleon
it with alcohol prior to installation.
1. Pushthe bulb straight into the receptacle
all the way.
2. Replacethe light cover, by placing its
front edge under the front two tabs in the light
compartment. Roll t he back edge into place,
making sure that it isfirmly seated.
NOTE:If the locking clips fell from the glass lens
cover,hold them on the cover,in the correct
position,while replacingthe cover on the light
compartment.
Place front
edge of
lens cover
under front
two tabs
Pressthe light coverinto place
The light cover must be in place when using
the oven.
3. Reinstallthe rack support. Besure to orient the
support so that the top tabs for the nuts are
closestto the top of the oven. Lightlysecure
with the four nuts removed earlier,but do not
over-tighten or the enamel could be chipped.
[ i
4. Replacethe racks, Seethe Fullextensionoven
racks section.
5. Reconnect electrical power to the oven,