Table of Contents
Advertisement
2
Press the Menu
Then press the Start
of the two polling options: SEND (Transmission Polling setup) and
CONT. (Continuous Polling). (For continuous polling, refer to
page 4-9.)
3
Press the Start
to enter a 4-digit poll code.
Note: If there is a document in memory to be polled, a "FUNCTION FULL
SETTING" is displayed.
Note: The poll code is preset to 0000 at the factory. This setting represents
no poll code required for the remote.
4
If you want to use a poll code, enter a 4-digit code (except 0000).
3-40
Sending a Fax
button, then press the 0 + 9 buttons on the keypad.
button. The display prompts you to choose one
button to confirm SEND. The display prompts you
Advertisement
Table of Contents
Troubleshooting
