Calibration; Cleaning; Abnormal Conditions - LeCroy WaveRunner Xi series Operator's Manual

Always use the On/Standby switch to place the DSO in Standby state so that it executes a proper shutdown
process (including a Windows shutdown) to preserve settings before powering itself off. This can be
accomplished by pressing and holding in the On/Standby switch for approximately 5 seconds.
Note: To power off, place the DSO in Standby state, then disconnect the power cord.

Calibration

The recommended calibration interval is one year. Calibration should be performed by qualified personnel only.

Cleaning

Clean only the exterior of the instrument, using a damp, soft
cloth. Do not use chemicals or abrasive elements. Under no
circumstances allow moisture to penetrate the instrument. To
avoid electrical shock, unplug the power cord from the AC outlet
before cleaning.

Abnormal Conditions

Operate the instrument only as intended by the manufacturer.
If you suspect the DSO's protection has been impaired,
disconnect the power cord and secure the instrument against
any unintended operation.
The DSO's protection is likely to be impaired if, for example, the
instrument shows visible damage or has been subjected to
severe transport stresses.
Proper use of the instrument depends on careful reading of all
instructions and labels.
WRXi-OM-E Rev C
O
PERATOR
WARNING
Electric Shock Hazard!
No operator serviceable parts inside. Do not
remove covers.
Refer servicing to qualified personnel.
WARNING
Any use of the DSO in a manner not specified
by the manufacturer may impair the
instrument's safety protection. The instrument
and related accessories should not be directly
connected to human subjects or used for patient
monitoring.
' M
S ANUAL
31