Edge Trigger Setup - LeCroy WaveRunner Xi series Operator's Manual

W R X S
AVE UNNER I
Alternatively, in the Trigger dialog, you can touch inside the Level field and type in a value, using the pop-up
numeric keypad. To quickly set a level of zero volts, touch the Zero Level button directly below the Coupling
field.
An arrow on the left side of the grid shows the threshold position. This arrow is only visible if the trigger source is
displayed.

Edge Trigger Setup

C S
HANNEL ETUP
1. In the menu bar, touch Trigger, then select Trigger Setup... from the drop-down menu.
2. Touch the Edge trigger button
3. Touch inside the Trigger Source field and select an input from the pop-up menu.
4. Touch inside the Level field:
5. In the pop-up numeric keypad, enter a value in millivolts or use the up/down buttons to increase or decrease
the value in increments of 1 mV. Or, touch one of the preset value buttons:
6. Select the holdoff by touching the Time or Events buttons
,
7. Using the pop-up numeric keypad, enter a value and specify the unit of time:
8. Or, use the up/down buttons to increase or decrease the time value in increments of 100 µs. Or, touch one of
the preset value buttons:
62
ERIES
under the Trigger tab.
WRXi-OM-E Rev C