Table of Contents
Advertisement
Parameter
Description
Period
Period of a cyclic signal
measured as time between
every other pair of 50%
crossings. Starting with first
transition after left cursor,
period is measured for each
transition pair, with values
averaged to give final result.
Period@level
Period at a specified level and
slope for every cycle in
waveform.
Phase
Phase differ
signal analyzed and signal
used as reference. You can set
the output type to percent,
degrees, or radians. After
setting up the reference, touch
the More tab for signal setups
Pop@X
Populatio
horizontal coordinate. You can
place the cursor at any bin and
use either Absolute, Reference,
or Differ ence cursor shape.
PW50
Average pulse width at the 50%
point between the local
baseline and the local peak or
trough.
PW50-
Average pulse width at the 50%
point between the local
baseline and the local trough.
PW50+
Average pulse width at the 50%
point between the local
baseline and the local peak.
WRXi-OM-E Rev C
ence between
Phase difference between
signal and reference
.
n at bin for specified
Definition
O
'
M
PERATOR
S
Notes
Where: Mr is the number o
leading edges found, Mf
number of trailing edges
found,
the time when
rising edge i crosses the x%
level, and
the time wh
falling edge i crosses the x
level.
Standard pa
rameter.
Reference levels and
edge-
transition polarity can be
selected. Hysteresis
argument
used to discriminate levels
from noise in data.
Available with JTA2 and
XMAP options.
Standard parameter.
Available with DDM2, JTA2,
and XMAP options.
Standard in DDA-5005A.
Hysteresis argument used to
discriminate levels from noise
in data.
Available with DDM2 o
ption.
Standard in DDA-5005A.
Hysteresis argument used
discriminate levels from no
in data.
Available with D
DM2 option.
Standard in DDA-5005A.
Hysteresis argument used
discriminate leve
ls from noise
in data.
Available with DDM2 option.
Standard in DDA-5005A.
ANUAL
f
the
en
%
to
ise
to
121
Advertisement
Table of Contents
