Table of Contents
Advertisement
W
R
X
S
AVE
UNNER
I
Cursors Setup
Quick Display
At any time, you can change the display of cursor types (or turn
dialog as follows:
1. In the menu bar, touch Cursors, then Off, Abs Horizontal, Rel
2. The cursors displayed will assume the positions previously s
measurement mode, in the menu bar touch Cursors, then Cursors Setu
Full Setup
1. In the menu bar, touch Cursors, then Cursors Setup. The Standard Cursors dialog opens.
2. In the dialog area, touch the Cursors On check box to display them.
3. Touch one of the Horizontal or Vertical mode buttons: Relative or Absolut
4. If you chose a Relative mode, also touch a rea
5. If you chose a Relative mode, touch inside the Position
cursor. You can also use the Cursors knobs on the front pa
mode, do the same for your single cursor.
6. If you chose a Relative mode and you would like both c
touch the Track check box to enable tracking.
Overview of Parameters
Parameters are measurement tools that det
automatically calculate many attributes of your waveform, like rise-t
for example.
There are parameter modes for the amplitude and tim
pass and fail testing. You can make common
Turning On Parameters
1. Touch Measure in
the menu bar, then Measure Setup... in the drop-down menu.
2. Touch inside the On checkbox for each parameter you want to display.
Quick Access to Parameter Setup Dialogs
You can quickly gain access to a parameter setup dialog by touching the parameter list box below the grid. For
example, touching within P1 below the grid
displays the setup dialog for P1:
Touching the row titles displays the top Measure dialog.
100
ERIES
ermine a wide range of waveform properties. Use them to
measurements on one or more waveforms.
them off) without invoking the Cursors Setup
Horizontal, Abs Vertical, or Rel Vertical.
et up. If you want to change their position or
dout parameter button: Y position, delta Y, or slope.
1 and Position 2 fields and type in a value for each
nel to place the cursors. If you chose an Absolute
ursors to move in unison as you adjust the position,
ime, rms voltage, and peak-to-peak voltage,
e domains, custom p
p in the drop-down menu.
e.
arameter groups, and parameters for
WRXi-OM-E Rev C
Advertisement
Table of Contents
