Interface; Auxiliary Input; Auxiliary Output; Math Tools (Standard) - LeCroy WaveRunner Xi series Operator's Manual

Interface

•
Remote Control: Through Windows® Automation or LeCroy remote command set
•
GPIB Port (optional): Supports IEEE-488.2
•
Ethernet Port: 10/100Base-T Ethernet interface (RJ-45 connector)
•
USB Ports: 5 USB ports (one at front of oscilloscope) support Windows compatible devices.
•
External Monitor Port (standard): 15-pin D-Type SVGA compatible DB-15; connect a second monitor to use
dual monitor display mode
•
Parallel Port: 1 standard
•
Serial Port: DB-9 COM1 port (not for remote control of oscilloscope)

Auxiliary Input

Signal Types: Select External Trigger or Clock input on front panel.

Auxiliary Output

•
Signal Types: Select from calibrator signal on front panel or control signals output from rear panel BNC.
•
Calibrator Signal: 250 Hz to 1 MHz square wave or DC level; 50 mV to 1.0 V (selectable) into 1 kohms
•
Control Signals: trigger enabled, trigger out, pass/fail status, or off

Math Tools (standard)

Display up to four math function traces (F1 to F4). The easy-to-use graphical interface simplifies setup of up to
two operations on each function trace. Function traces can be chained together to perform math-on-math.
•
absolute value
•
average (summed)
•
average (continuous)
•
copy
•
derivative
•
deskew (resample)
•
difference (-)
•
enhanced resolution (to 11 bits vertical)
•
envelope
•
exp (base e)
•
exp (base 10)
•
fft (power spectrum, magnitude, phase)
•
floor
•
histogram of 1,000 events
•
integral
•
invert (negate)
WRXi-OM-E Rev C
•
ln (log base e)
•
log (base 10)
•
MATLAB math
•
product (X)
•
ratio (/)
•
reciprocal
•
rescale (with units)
•
roof
•
segment
•
segment
•
(sinx)/x
•
square
•
square root
•
sum (+)
•
trend (datalog) of 1,000 events
•
zoom (identity)
O ' M
PERATOR S ANUAL
19