Component Status Conditions - HP Surestore Disk Array 12h - And FC60 Advanced User's Manual

Component Status Conditions

Component status conditions are organized into the categories listed in
interpretation and action associated with a status depends on the component. See
on page 379 for more information on Disk System SC10 component status.
The component status condition terminology used by Array Manager 60 (AM60) may differ
from that used by STM. Both terms are identified in the table.
Table 42 Component Status Conditions
Status
AM60: Good
STM: Optimal
AM60: Non-critical
STM: Fault - 3
AM60: Critical
STM: Fault - 2
AM60: Not Installed
STM: Not Present
AM60: Unknown
STM: Fault - 0
Description
The component is operating normally.
A component or condition such as temperature or voltage
has exceeded warning limits.
Although immediate action is not required, the cause of
the non-critical status should be investigated and
corrected if necessary.
A component has failed or a condition such as
temperature or voltage has exceeded critical limits.
Immediate action is required.
The component is not installed.
The status of the component cannot be determined.
Status Conditions and Sense Code Information
Table 42. The
Table 51
321