Table 37
Command Options for Displaying Disk Array Status (cont'd)
Option
Status Information Displayed
-a
All status. This option displays all the information returned by the
preceding options.
-p <devicefile>
Hardware path information. Displays hardware path information for
the controller corresponding to the specified device file.
-r
Rebuild status. Display the progress of any rebuilds occurring on the
disk array.
-A
Array server status.
Command Example
The following example all status information for disk array Array1.
amdsp -a Array1
A sample out put from this command is shown in
identified with the normal values.
Missing UTM LUN 31
Note
If the required patches for HP08 firmware are not installed on the host, the host
will not recognize or display UTM LUN 31. If LUN 31 is not displayed, install
the required patches as described in
on page
214.
Figure
88. The important fields are
"Installing the Disk Array FC60 Software"
Managing the Disk Array Using Array Manager 60
283